Seal Dimensions 14

1-1/4″ (1.25″) SHAFT (continued) to 1-3/8″

AS&P

Seal Products

How about upgrading to a cartridge type mechanical seal?

As you increase in size a cartridge seal can often make more sense than a single spring seal. 50% of seal failures are due to poor installation. A simple mistake can cost you big bucks. Cartridge seals eliminate installation errors because the seal faces, elastomers, gland, and sleeve are all self-contained. Attach it to the pump and remove the setting clips and you are off and running. If your replacing a single spring seal there usually is no plumbing to connect however most cartridge designs allow you to flush through the gland increasing the life span of the seal. Initially, a cartridge seal will be more expensive due to the included gland and sleeve, but with the reduction in seal failures due to imperfect installation, and the extended life cartridge seals usually save you money in the long run. You can view our cartridge seal options at https://usseal.com/mechanical-seals/ or https://www.sealsales.com

American Seal & Packing – DIMENSIONAL CROSS REFERENCE BY SHAFT SIZE

1-1/4″ (1.25″) SHAFT (continued) to 1-3/8″

single spring mechanical seal dimensions 14

Mechanical seal dimensions

Seal Material Codes

Notes:

  1. Mounts on shaft
  2. Tappered spring
  3. EPR should not be used with Petroleum based products
  4. With cup mount seat
  5. Lock collar sold seperately
  6. Seat is slotted
  7. Spring holder not included

Mechanical Seals

AS&P Mechanical Seal information sites

Get In Touch

(888) 654-SEAL

Location:
1537 E. McFadden Ave-A
Santa Ana, CA. 92705

Email:
sales@usseal.com

Technical Support:
technicalsupport@usseal.com

Open Hours:
Mon: 7:30am - 5pm
Tue: 7:30am - 5pm
Wed: 7:30am - 5pm
Thur: 7:30am - 5pm
Fri: 7:30am - 5pm
Sat: Closed
Sun: Closed

Send A Message

Online Store